CONSTRUCTION OF INDUSTRIAL BARROW
By
EBITE – JOHN FRANCIS
Presented To
Department of
Chemical Engineering
ABSTRACT
The constructional project involved the construction of an industrial barrow of standard size was constructed.
The process used went across various Engineering practice. These involved the procurement of galvanized steel of 0.00mm to 300mm thickness. Some galvanized steel rods and pipes were also used for the construction.
The Engineering drawing was done followed by the following operation: Marking out, cutting, bending and folding.
Finally, the construction of an industrial barrow was done successfully and clean, portable and standard industrial barrow was obtained. These industrial barrows can be used in material handling activities.
TABLE OF CONTENTS
Title page
Dedication
Acknowledgement
Letter of posterity / Transmittal
Abstract
Content
CHAPTER ONE
1.0 Introduction 1.1 Origin and History
1.2 Aim
CHAPTER TWO Literature review
CHAPTER THREE 3.0 Sequence of operation
3.1 Prototype construction
3.2 Operation description
3.3 Material analysis
3.4 Testing of construction and analysis
3.5 Testing and results.
CHAPTER FOUR 4.0 Cost evaluation
4.1 Cost of standard wheel
CHAPTER FIVE Discussion
CHAPTER SIX Recommendation
Conclusion
CHAPTER SEVEN Bibliography
