The design and fabrication of a reciprocating nail gasket is a new innovation in technology. The one in existence is manually operated. In which a punch that is adjacent to a die is mounted to the handle  which  is attached to the shaft. A helical spring that is incorporated to the shaft of the punch, helps the handle return to its initial position, which makes the machines tedious and stressful to operate. When the handle is pulled down from its initial position, the punch passes through the die that is placed  vertically adjacent to the punch thereby blanking out the felt materials. The number of the gasket produced is proportional to the strength of the operator. But in our design, we incorporated  a geared motor which does the cutting in a reciprocating form, while the operator  just drags the felt material to the die where it is cut. The efficiency  of the machine is well above 75%, it can produce 216 felts per minutes . sprockets and chains are used to transfer power  instead of belts in other to effect good phases relationship. The material used for the punch is stainless steel rod. The machine is statically and dynamically balanced to curb noise and vibration. One and half (11/2) inch angle iron was used in fabricating the skeletal frame.
Appropriate materials were subsequently selected and fabricated to required size. The machine was then  to perform efficiently thus satisfying the objective for which it was designed.

Title page    
Approval page
Dedication
Acknowledgement
Abstract
Table of content

CHAPTER ONE: INTRODUCTION
1.1    Background of study
1.2    Purpose of study
1.3    Scope of study

CHAPTER TWO:    LITERATURE REVIEW
2.1    Specification of problems
2.2    Field survey/study
2.3    Different types of gasket and their uses

CHAPTER THREE: DESIGN CONSIDERATION, SPECIFICATION AND CONSTRUCTION
3.1    Design factors/Consideration
3.2    Material selection
3.3    Tools and Equipments Employed
3.4    Design of welded Connections

CHAPTER FOUR: DESIGN CALCULATIONS AND ANALYSIS OF THE MACHINE
4.1    Forces analysis on the reciprocating mechanism
4.2    Calculating the displacement, velocity and acceleration of the slider
4.3    Estimating the power of the geared motor
4.4    Chain length calculation
4.5    Design of sprocket teeth for roller chain
4.6    Chain drive selection
 
CHAPTER FIVE: FABRICATION PROCEDURE, MATERIALS SELECTION, PRINCIPLE OF OPERATION AND COST ANALYSIS.
5.1    Fabrication Procedure
5.2    Materials selection
5.3    Cost analysis
5.4    Guidelines in Designing for production
Recommendations
References