CONSTRUCTION OF RLC (RESISTOR, INDUCTOR AND CAPACITOR) IN OSCILLATORY CIRCUIT IN PARREL AND IN SERIES
By
OZOR MOSES CHUKWUNONSO
Presented To
Department of Science Laboratory Technology
ABSTRACT
This is the construction of an RLC and RC circuit network use in generation is different signal in RLC mod. After the complete construction of the system, the deviation between the expected result and the actual result was very close. The performance and efficiency was beyond expectation and from every ramification, the construction of RLC circuit was successful. Going through the planning, flow process, construction and software implementation, the system had really been a tough one using proteus visual simulation software was not an easy task, but on the whole it has been a chance to show-case a little bit of craftmanship.
TABLE OF CONTENTS
Title page i
Certification ii
Dedication iii
Acknowledgement iv
Abstract v
Table of contents vi
CHAPTER ONE
1.0 Introduction 11.1 Background of the study 1
1.2 Aims and objective 3
1.3 Scope of the study 4
CHAPTER TWO
2.0 Literature review 5 2.1 History 5
2.2 Application of RLC circuit 8
2.3 Oscillators RLC circuit 13
2.4 Voltage multiplier of RLC circuit 14
2.5 Pulse discharge circuit 15
2.5.1 Basic concepts linear analog electronic filters 17
2.5.2 Natural frequency 20
2.5.3 Damping 22
2.5.4 Band width 23
2.5.5 Q factor 24
CHAPTER THREE
3.0 Materials and methodology of the project 273.1 Materials 27
3.2 Description of each material 27
3.3 Construction procedures 46
CHAPTER FOUR
4.0 Testing, operation and speci-fication 484.1 Testing 48
4.2 Operation 51
4.3 Specification 52
CHAPTER FIVE
5.0 Conclusion and Recommendation 54
5.1 Conclusion 54
5.2 Recommendation 54
References 56